The light varnish YKSUV - 004


This series of products are mainly used in ABS, PC, such as plastic directly on the surface of the polishing, fast drying, high hardness, adhesion to the substrate, coating the fullness of the light, in a variety of toys, helmet, there are widely used on electric vehicle plastic parts.


Epoxy acrylate monomer, light initiator, additives, etc.

Technical indicators:


The construction technology:

1, the processes:

Artifacts - surface spray cleaning - > UV lacquer - 50 ℃ ~ 55 ℃ flow flat for three minutes to UV curing paint, inspection and packing

2, coating:

Dilution ratio: paint, thinner, = 2:1

Spraying viscosity: 9 ~ 10 seconds (Mr Iwata # 2 cups)

Curing conditions: ultraviolet light intensity of 700 ~ 800 mj/m2


1, the substrate must be clean.

2, UV varnish must use 600 purpose filter cloth before use double filtering.

3, strict assurance flow flat temperature and time.Between 50 ℃ ~ 55 ℃ to ensure the flow of time more than three minutes, otherwise it will affect the performance of the paint film.

4, adhesion due to a vision of the substrate is different, please make confirmation in advance.

5, avoid direct sunlight, avoid UV container openings for a long time exposed to bright light.

6, airbrush tools need to use special cleaning agent to clean.

7, avoid direct contact with the skin UV paint, protective glasses and gloves should be worn when operating, if the UV paint splashed on the skin, should be washed with soap and water immediately.

8, do not look straight into the UV lamp, in order to avoid burns.

Is the above information and my company in the experiment under special conditions, for reference only, actual operating conditions please make your own test.

清远雅克化工有限公司 @ All rights reserved 2015 | 粤ICP备06084242号 | The website construction:Qingyuan rubik's cube network
address:Qingyuan city, guangdong province high-tech development zone Silver light jia fu jia by 16 industrial zone tel:0763-3607328